
一、产品简介
I Product Introduction
在高锰酸钾中多层板除胶渣的体系中,作为树脂的膨松剂,用作使孔内涵钻孔后的胶渣硬化,利于后工序之高锰酸钾把胶渣扫除,使孔壁成为亲水性,内不含络合剂,废水处置复杂。
In system of removing smear in multi-layer board by potassium permanganate, the sweller can soften the smear in hole after drilling, which is beneficial for later procedure of removing smear by potassium permanganate, so the hole wall will be hydrophilic and has no complexing agent; the treatment of sewage is simple.
二、配槽办法
II Makeup Method
1L槽液
1L solution |
次要作用
Main Function |
体积(ml)
Volume |
纯水
Pure water |
溶剂
Solvent |
700ml |
片碱
Sodium hydroxide |
提供碱情况
Provide alkaline environment |
8g/L |
HSD-001 |
蓬 松
Fluffy |
300ml |
三、操纵条件
III Operating Condition
组份/参数
Component/Parameter |
最佳值/事情范畴/要求
Optimal value/Work Scope/Requirement |
温 度
Temperature |
60℃(60-70℃) |
时 间
Time |
5min(5-10min) |
摇 摆
Swing |
细微的机器摆动
Slight mechanical swing |
槽体材质
Material of bath |
P.P质料
PP material |
加热器
Heater |
钛、石英或铁弗龙
Titanium, quartz or Teflon |
过 滤
Filter |
必要
Required |
四、添加量
IV Additive Volume
每消费1000ft2补加HSD-001 4L
Supplement HSD-001 4L for producing 1000ft2;
五、控制与维护
V Control and Maintenance
每升事情液处置400-500ft2时换缸
Change bath when each litre of working solution processes 400-500ft2;
六、浓度剖析
VI Analysis of Concentration
a) 量取25ml于100ml量筒中;
a) Measure 25ml and place it in a 100ml measuring cylinder;
b) 加水25ml;
b) Add 25ml water;
c) 参加8g NaOH搅拌;
c) Add 8g NaOH and mix;
d) 待运动冷却后读取下层液毫升数;
d) After being still and cooling down, read the ml of upper liquid;
e) 盘算:浓度%=ml×9.1
e) Calculation: concentration %=ml×9.1
七、宁静防护
VII Safety Protection
利用时请佩带眼罩、手套及穿宁静防护衣。若药液失慎溅及皮肤、眼睛时使用少量净水洗濯,严峻者应立刻就医诊治。
When using it, please wear eyeshade, gloves and protective clothes; in case that solution spatters into eye or on skin, immediately flush with plenty of clean water and get medical treatment if necessary.. |